When you want to run Windows 95, use the Attach Hard Disk command under the Options menu to select the C: drive file with Windows 95 on it, and then reset SunPCi. If you want to “dual-boot” SunPCi software with both Windows NT and Windows 95, simply create another C: drive. To install Windows NT on your SunPCi system, you create a new C: drive and install Windows NT to it. The setup and configuration procedures for the SunPCi 1.1 software involve some different steps. The system name for your SunPCi card on your network and the workgroup name for your Windows NT installation on SunPCiįollow the installation procedures in this section, even if you have installed Windows NT on a PC before. Windows NT Service Pack 4 (CD-ROM or downloaded image) Windows NT Workstation 4.0 CD-ROM (full install version) ![]() ![]() ![]() Make sure you have the following available before you start installing Windows NT: Make sure you install Service Pack 4 before using Windows NT on SunPCi otherwise, you may experience unpredictable results. After you install the SunPCi software, you can install Windows NT and Service
0 Comments
Leave a Reply. |